- 773-992-1647
- Open 24 hours
Reach out today for expert service, fast repairs, and friendly support. We’re here to help!
Upgrade your comfort now and pay later with our flexible, budget-friendly HVAC financing options.
Save big on your next service! Check out our latest seasonal deals and exclusive HVAC discounts.
Fewer than a thousand households sit inside Kenilworth’s original village plan, and many of those homes date to the 1890s through the 1920s. Plaster walls, retrofitted duct chases, and mechanical rooms that were never designed for modern equipment mean a furnace repair here is as much about the house as the appliance.
Elite HVACS handles that work with care. Our NATE-certified technicians diagnose thoroughly and protect the home while they do it.
In a home of this vintage the warning signs tend to be subtle.
Investigating early is cheaper than an emergency call, and less disruptive to the house.
Century-old homes often run heating systems assembled in layers, with a modern furnace connected to ducts and returns adapted from earlier decades. That mismatch produces its own failures. Static pressure runs high, the blower works past its rating, and the limit switch shuts the unit off before the far rooms warm up.
On the equipment side we find cracked heat exchangers, worn inducer assemblies, control boards damaged by moisture in old basements, and gas valves drifting out of specification. Establishing which layer of the system is failing comes before any part gets ordered.
Our process is deliberate because these houses deserve deliberate work.
You hear what we found and why, in language that actually explains it.
Ellen’s furnace kept shutting off after about fifteen minutes, and two prior visits had produced two different guesses. Our technician measured static pressure and found the system choking on a single undersized return in a 1908 home. He corrected the return opening and replaced a limit switch weakened by repeated tripping. The furnace has run full cycles ever since.
What earns repeat calls in a village this small is consistency.
We treat each home with care and respect, and we explain the work without ever making you feel talked down to.
Our furnace repair service covers Kenilworth and the villages immediately around it, including Wilmette, Winnetka, Evanston, Glencoe, Northfield, Skokie, and Glenview. Within Kenilworth we work throughout the original Sears plan, the blocks east of Green Bay Road, and the streets bordering Sheridan Road.
These communities sit within a few minutes of each other, so winter emergency response stays fast across all of them.
Yes, provided the ductwork and returns can move the air the unit is rated for. Many comfort complaints in historic homes come from distribution rather than the furnace, which is why we measure airflow during every diagnostic.
Yes. We plan the route to the mechanical room, lay protection over finished surfaces, and clean up fully before leaving. Working carefully inside older homes is a normal part of the job here, not a special request.
That pattern usually points to a limit switch tripping on high heat, which happens when airflow across the exchanger is restricted. Dirty filters, closed returns, and undersized duct openings are the common causes, and all are correctable.
Yes. Older North Shore homes often have one of each, or a hybrid setup after a renovation. Our technicians are trained across furnaces, boilers, and air handlers, so a single visit can cover the whole heating system.
It is not something to diagnose visually from outside the cabinet. We inspect the exchanger directly and test combustion during service. If we find a crack, we shut the system down and show you the evidence before discussing next steps.
