- 773-992-1647
- Open 24 hours
Reach out today for expert service, fast repairs, and friendly support. We’re here to help!
Upgrade your comfort now and pay later with our flexible, budget-friendly HVAC financing options.
Save big on your next service! Check out our latest seasonal deals and exclusive HVAC discounts.
Evanston winters arrive straight off Lake Michigan, with wind that finds every gap in a house. Much of the housing stock here dates to the Victorian and early bungalow eras, from the Ridge Historic District to the two-flats south of Dempster, and many furnaces sit in tight basements beside original ductwork.
Elite HVACS repairs gas and electric furnaces across Evanston. Our NATE-certified technicians find the actual fault, explain it in plain language, and restore heat the same day whenever parts allow.
Older Evanston homes hide furnace trouble well, so the early signals matter.
Any one of these is worth a diagnostic before the next cold snap.
Evanston’s mix of retrofit forced air and original gravity duct runs creates a specific set of failures. Cracked heat exchangers show up in furnaces pushed past twenty years. Flame sensors coated with residue shut systems down mid-cycle. Undersized returns in converted homes overheat the cabinet and trip the limit switch.
We also see condensate drains freeze on high-efficiency units vented through north-facing walls, plus inducer motors worn thin by years of short cycling. Each one takes a different fix, so we test before recommending anything.
We follow the same process on every Evanston call so nothing gets skipped.
You get the reasoning behind the repair, not just an invoice.
Margaret called from a Victorian near Central Street after her furnace began shutting off ten minutes into every cycle. The thermostat looked fine. Our technician found a flame sensor buried in carbon and a return vent blocked by a stored rug, which was overheating the cabinet and tripping the limit. He cleaned the sensor, cleared the return, and confirmed a full cycle. Her heat has held steady since.
Homeowners here keep our number for a few plain reasons.
We live and work in these same suburbs, so a no-heat call in Evanston is a neighbor’s problem, not a ticket number.
Our furnace repair crews cover Evanston and the communities around it, including Skokie, Wilmette, Lincolnwood, Morton Grove, Kenilworth, Glenview, and Niles. Within Evanston we work throughout Northwest Evanston, the Ridge Historic District, South Evanston, and the Central Street and Dempster corridors.
If your home sits near any of these areas, a technician is usually close by during heating season.
We offer same-day service and keep 24-hour emergency availability through the heating season. During a cold snap we prioritize homes with no heat at all, especially those with young children or older residents.
It can be. Many homes here were converted from gravity heat or boilers, and undersized returns make a healthy furnace look faulty. We measure airflow during the diagnostic so we can separate a duct problem from a furnace problem.
It depends on the age of the unit, which part failed, and whether the heat exchanger is sound. We give you both paths with the reasoning behind each and let you decide. We do not push a replacement when a repair will hold.
A cracked exchanger can let combustion gases reach your living space, so we treat it as a safety issue rather than a comfort one. We shut the system down, show you what we found, and walk through your options before restarting anything.
Yes. Condensing furnaces vented through an exterior wall are common in newer Evanston builds and gut rehabs. Frozen condensate lines and blocked intakes are frequent winter culprits, and both are straightforward to correct once identified.
